Featured Products

Product Code #: Allied Bolt Products
Allied Bolt Products 10" SOCKET ANCHOR 10000 FT. LB. FOR 3/4" AND 1" RODS
Part #: 3512

Installation is performed using a drive wrench which fits into the anchor hub.
Proper anchor selection depends on the type of soil and guying requirements.

10" SINGLE SOLID SQUARE HUB HELIX POWER DRIVEN ANCHOR-
4000 FT LB
Part #: 3406

Installation is performed using a power digger. An anchor wrench fits over the square hub and a torque measurement device is required to determine proper installation.

Correct installation is achieved only when the anchor is installed using the appropriate torque for the particular soil and anchor type (see reference charts).

Proper anchor selection depends on the type of soil and guying requirements.
Installation torque is usually measured using a device connected in series with the wrench, digger, and Kelly Bar during installation.

12" SINGLE SOLID SQUARE HUB HELIX POWER DRIVEN ANCHOR 1-3/8" HUB FOR 3/4" & 1" RODS - 4000 FT. LB.
Part #: 3408

Installation is performed using a power digger. An anchor wrench fits over the square hub and a torque measurement device is required to determine proper installation.

Correct installation is achieved only when the anchor is installed using the appropriate torque for the particular soil and anchor type (see reference charts).

Proper anchor selection depends on the type of soil and guying requirements.
Installation torque is usually measured using a device connected in series with the wrench, digger, and Kelly Bar during installation

5/8" X 12" SQUARE HEAD MACHINE BOLT WITH NUT
Part #: 8224

-Used for fastening poleline hardware to crossarms, poles, and other structures
-Has a formed "cone point" to ease attachment of nut
-Allied Bolt marking (ABI) appears on the head of each bolt
-Hot dip galvanized to meet ASTM Specification A153
-Supplied with attached square nut
-Minimum tensile strength: 13,550 lbf
-Recommended torque value: 73 ft lb
-Minimum thread length is 6"

STANDARD EYELET
Part #: 2054

-Used with machine bolts for dead-ending
-Forged from high strength AISI 1018 Steel
-Rated to support a 32,000 lb. load
-Slot size is 11/16" x 1-1/8"
-Height is 4-1/8"
Inquire